Changeover Switch LW28-63 3 Positions 16 Terminals Universal Rotary Cam Selector Latching Switches 690V 63A

Bought the 63A varient, thinking I'd rather have something thats rated for more amps than needed. I'm using it to run a 120VAC lathe that has a pretty hard inrush current draw. Switch has a nice satisfying click when turned to the left/right of center. Little softer when turning back to center. But, it had a decent amount of weight and felt pretty solid. Mine did come damaged, the bottom-corner was broken off during shipping. Though this didn't cause any issues with use.

It worked great in my RC to switch from solar o shore power

I used this switch for zone 2 and zone 3 stereo speakers. It is a 3 position switch, off, 1 and 2. In my use it is either zone 1 or zone 2, but not both at the same time. It works and is way cheaper than the cheapest audioswitch available.

Good switch in an RV, BUT the screw mounts on the back of the plate are a bit flimsy...best to use nuts if you can find them.

I used it to create an inverter bypass switch in my travel trailer. No problem with the 12 gauge wire. Solid construction. I am confident that it is a quality piece. No issues and I’d certainly buy it again.

Thanks

I needed a switch that would let me disconnect the solar from feeding the subpanel in my shop and give me the option of connecting the shop sub panel to my generator, which is portable. Because of the way safety is maintained by complying with code, regarding ground neutral bonding, I wanted to switch that would disconnect not just the hots, but also the neutral in the ground so I could maintain my solar inverter system as the source of ground because it is the source of power and still leave my portable generator bonded without creating two neutral ground bonds in one system . This switch allowed me to do that for my 3000W system with a positive disconnect of the neutral and ground.

Poorly constructed. I've been in the Electrical business for 40+ years and have extensive experience with Hand-Off-Auto switches. When this switch failed to operate (no make or break contacts in any switch position) I decided to disassemble and see why. What I found was the gap in the Cam (see picture) is not wide enough for the full travel of the switch positions. Even though I was extra careful, unfortunately I lost a contact assembly and this is now junk. I can't in good conscience return