COFAIR PROD Cofair WQR325 Quick Roof Pro Aluminum White 3" x 25'

Worked good with proper install. Surface prep is important....make sure it's clean as possible. Note that the adhesive wasn't sticky cold off the roll. I used a heat gun to very gently heat the adhesive prior to application. Once warmed up the tape stuck really good.

We had a small gap in the roof where the roof met the house. This worked great at covering it, while still looking nice. it’s very sturdy stuff!

This is a amazing Product..... Bought six rolls and just got done using 3 of them on the front edge of my trailer roof. I had my rood coated with the white silicone but the edge was bad so we used this as a wrap over. We put 2 inches of it on the roof and had one inch of it fold over to the side of the house. All we did was clean the surface with Windex and wait for it to evaporate (30 seconds) and rolled on the tape. This tape stuck so good that you could not move it once it touched any spot it touched. Once in position we used a (MARSHALLTOWN The Premier Line E54D 2-Inch Flat...) roller from Amazon and it was like it was welded on. Clean surface is the key to any job like this and when i looked at other negative reviews of this all I saw was bad prep before use. All I can say is this stuff will not let you down as long as you have a clean surface. I am doing the other side this week when we have a clear day and I will take pictures and post them here. 5 stars all the way on this....Never thought it was going to work this well.

You must heat more than it says to. My husband ended up using a blow torch to heat the metal then applied the tape and it adhered great.

This stuff is good. One needs to ensure the surface/s are CLEAN! And use a one inch roller to make sure it is making contact completely once you have it where you want it. I installed it on a lateral seam, completely across the trailer. The two sheet metal pieces were originally folded and crimped, but not perfectly. An approximately 8 inch long area came apart and leaked. After finding the place and putting the tape on, no leak.Putting this stuff on a smaller area with multiple pieces could be very exasperating. It sticks very well and is not attuned to being removed and repositioned. It likes to stay where it is put. But, if one is creative, patient, and takes their time.....should not be a big deal.OBTW.....It says 3" x 25'. The one I received wasn't. It was 3" x 32'. I'll buy more!

This item was easy to install, the true test will be when it rains.

This Quick Roof, white aluminum adhesive tape works good. It was easy to roll out and cut into the lengths that I needed. I was able to cover the seams of the RV bathroom vent easily and quickly.

Like it's "aluminum" brother, this crap is a complete waste of money! As per my review for the "Cofair's" other (silver) version, this stuff also lifted within 4 months of application. I like to try a variety of products, in different areas of a job to see which actually performs. All conditions are the same: material - weather factor - etc and this junk didn't live up to any reasonable expectation or standard. NO way are you going to waste your time and money to have a product completely fail within weeks of PROPER application. The ONLY "Quick Roof" product that did not loose adhesion, at least within a 6 month time lapse, was their "Ultra Bond"/Steel Lock". In addition to lifting off applied site, all instructions followed to the letter, the entire (remaining) roll was a waste! The adhesive quality seemed to "disintegrate"!! It was stored indoors and in a temp controlled environment and yet, "Poof!" all adhesion GONE from the product and rendering the whole roll a waste after less than 3 months on "standby" on a shelf. Truth be said, considering the product FAILED miserably, I would be foolish to use it again anyway but still - it's like the company held you up and stole the money from your wallet and that's just not right. If it can't keep it's ability to function sitting on a shelf, now you know why it failed on the job!