Smittybilt Low-Back Bucket Front Seat (Black) - 44801

nice seats, 8mm by 1,25 pitch mounting bolts, seats are going in a mg td replica

As advertised good value

I installed a set of these in a 61 Ford F100. I chose these due to their size. I wanted to keep the seat below the back window and as far back as possible due to long legs. They fit the bill perfectly.A couple things to consider:1. The material is fine but not the heaviest2. The seat backs are fixed at about a 90 degree angle so you have to mount the front edge slightly higher than the rear to be comfortable...at least for me.All in all I am satisfied with the construction and quality of the seats.

This is just what I wanted, and all I had to do to get these cj seat to fit the stock yj seat brackets was to long gate two of the four holes about maybe a 1\2 inch. I have had them for about one year and are working good. If I wasn't so old I would buy another set for when these wore out.

This is generic but the passenger seat does not have a locking hook to keep the seat attached to base. Had to add a hook so seat will not dislodge and toss my passenger out in an abrupt stop. Not sure why they would not provide this for passenger seat that needs to lift up and over to get into back seat.

Fit passenger side. Added angle iron to drivers side. Looks good, comfortable low backs.

I needed better seats for a deuce and a half I'm restoring, but wanted something that looks stock. These seats fit the bill. Had to make a custom mount for the driver's seat, but nothing a couple of pieces of steel bar couldn't solve. Passenger seat just involved drilling some holes in the stack bench seat rack, which then allowed me to build a custom center console. Seats are pretty comfy for what they are – not luxury seats, but do they do their job well. All in all, I'm happy, especially since it's hard to find seats that'll fit in old military vehicles without major modification. For my purpose, I'd buy these again in a heartbeat.

Like the size, quality. Used as back seat in 1931 hot rod.

The seats are well built and look great ! A little firm but should soften with use. They fit my 8 way power seat frames like they were made for them !!