Flysky FS-X6B Receiver 6 CH 2.4G i-Bus PPM PWM Receiver for AFHDS i10 i6s i6 i6x i4x Transmitter with 250mm Lipo Battery Strap

I bought this to use inside my 3 pound combat robot.I have the iBUS output connected directly to my Arduino, which interprets the input and sends it to my custom motor drivers. I have access to all 10 controls from the remote transmitter through iBUS.I have had no issues with connection or stability, despite my robot being thrown in the air and whacked around in battle. This is all at short range, less than 50 feet. There were several other Flysky transmitters around, and no interference was noticed.Be warned, use a 100 ohm or lower resistor between the iBUS output and the Arduino, or it might not be recognized due to the lower output voltage of the receiver.I also covered the circuit of the receiver in hot glue to minimize vibration during robot battle, I don't know if this was needed, but I recommend it for robot combat.

This is easily and by far the best receiver even available for your flysky or equivalent radio. It has you covered at all angles to guarantee you'll be air born no matter your set up. It has pwm for servos or older traditional rigs, or ppm if needed for available sbus inverted pins, and of course it wouldn't be the best without having the reason your going to buy it, IBUS.The fastest, lowest latency protocol champion. Also, has additional perks like telemetry, voltage and small form factor. Anyway, look if you're running flysky this is the receiver you want. And I can say from first hand experience buying it here your dealing with a merchant that is engaged, and honest. Fpvking went well beyond their scope of culpability to ensure my customer experience was nothing less than stellar. So if your gonna get a receiver, you wouldn't go wrong dealing with this seller.

Fpv king had this receiver and I needed it. Is a good receiver, soldering it onto my flight controller on my tinyhawk s was fairly straight forward, and made easier by the fact that they send connector cables with the receiver. It has good antennas, and will go farther in range than my vtx and goggles, so I don't really know how far it will actually go. I use it mainly in thick treed areas no problem signal-wise. Yeah I fly in the woods.

Work great for me, just don't crash into a metal beam at full speed. Just ordered my 3rd to have a spare on Deck.EDIT: For Ibus the voltage is measured from the bottom single connection.. middle is + and the 2 sides are ground.. run them to the battery itself..

Works great, no rssi but I haven't had any fail safes and I flew around 3 baseball fields and a football feild

Nice packaged deal at a good price. The X6B receiver works great with decent range. I haven't had a failsafe or any dropouts, I fly 300m out max so I can't say I really push it. The RSSI telemetry works well with my FS -I6x. Overall I'm very pleased with the receiver. I have it in a Holybro Shuriken 250, fits with room to spare.

I’ve bought at least 3 of these (the first one came with the remote) and they all had the problem of the antenna mount coming unsoldered. The last one I bought came off before I even took it in the air, despite trying my best not to break it. And the first one that came with the remote was just a dud (it didn’t work at all.) I would give these a good review if it weren’t for the antenna mounts breaking. I’ve attempted to re solder them but I can’t get it to work. Really unfortunate because I like the way they mount to the stack.Also the holes to mount the receiver with are a bit small, and the led light is in a bad spot so it gets broken pretty easily. The holes are easily widened but it’s just a little frustrating. The LED is not a big deal but it just seems poorly thought out.

At first I was tempted to write a 1 star review because the receiver stopped working after a couple of minutes of use. Although, after contacting the seller and figuring out a solution the seller agreed to fix the issue by sending a replacement for free which is amazing because I really didn’t want to do the hassle of returning the product and then ordering another one. The new receiver had a green dot showing it was tested and worked fine. Overall great seller and one to buy from in the future for great customer service.