2 to 1 Heat Shrink Braided Sleeving 3/4" - 24 feet Pliable Shrinkable Fabric Sleeve for Protection Cable/Wire/Irregular Shape Hose

This is a semi-flexible, heat-shrink material that provides a softer, less abrasive option than nylon or PVC cable sleeves. The sleeve works very well and is much nicer to work with than other less mailable or less flexible polymer sleeve material. Add to that the ability to shrink the material lends to a more custom and professional appearance.

Used this to route wires around the engine bay of my car for a subwoofer. It shrank well and has held up well in the hot environment, and does a good job of hiding ugly wiring. It also shrinks fairly well and the material feels robust.

I replaced the wiring in my59 F100 and this was a great finishing look for the wiring. It was very easy to use.

I was skeptical on how good this stuff is, or would be. Color me surprised, I'm actually impressed. I used this to protect the hot end of a wiring harness where I wanted some flexibility, and didn't want some ugly rubber shrink tube. I ran this directly over some high temp convoluted tubing before shrinking, and didn't find much length shrink.With a bit of fancy work, I was able to tuck the ends under themselves before shrinking, giving a clean end which I liked. This will also breath, so if water ingress into the wrap is ever a concern, this won't prevent the water from evaporating and drying out - which is critical in an engine compartment.I wouldn't throw this over the top of an exhaust manifold, but it absolutely will resist normal engine bay temps and clean up your cabling, while offering some protection. Cuts with shears, remains flexible, but frays a bit at the end - you'll want to use heat shrink tube at the ends, and around any break out points.

Easy to use. Looks great on the car, cleans up the wire harness nicely.

it did what it needed to do. it was less flexible than I imagined it'd be. since I was wrapping a wire that wouldn't be moving it was less of a deal breaker. since it's not split (which would defeat the purpose) it was a bit of a PITA to get the wire through it. I finally used an improvised a fish tape to get my wires through it. it didn't shrink as uniformly as I imagined it would. not sure I'll buy again. it did keep the cabling clean an organized so there is that at least.

I bought this for UV protection on my 1/2" hydraulic hoses. It works as advertised and is tight against the hose after shrinking. The tube was able to go over the right angle fittings before shrinking the tube. The UV protection might be less than the material normally used for this purpose, however it much more cost effective.

Great product