PET Expandable Braided Sleeving 25Ft-1/2 inch Wire Loom, Aibole Braided Cable Sleeve Wire Wrap,Black&Red

First time using this product. It was a little tricky at first but worked out great.

We use it to protect my mom's oxygen hose from the cats and it works great. We've actually had people say they were going to recommend it to others for the same thing.

This is really nice once on but a little hard to use as the end unravels when feeding the wire through it. After putting on a ring of heat shrink and hitting it with the heat gun it looks good. I'm getting better with practice and likely would buy again.

Worked great for my trailer wiring project

Performing some upgrades/repairs on a classic vehicle plus repairs and new lighting on the big mower. Just a part of giving wiring upgrades a professional look

This cable wrap works like a Chinese finger puzzle: if you pull on it, it gets tighter. So, to run cables through it, they need to be pushed. Once a cable is all the way through, it is very difficult to add one. So, I found the best approach is to send them through one right after the other: as soon as the end plug of one is through, send the end plug of the next. repeat until all intended cables are inside and then finger-puzzle them through. I created a couple of 15' custom cable harnesses with this sleeving. It definitely cleans up the cable runs. As others pointed out, you need to melt the end where you cut it to prevent it from unravelling. I also set the ends with cable ties to make sure they didn't unravel over time from use/abuse.

This loom is not typical in that it is not split along the length, therefore you quite literally have to insert your wiring in one end, and inch it through the length. For a typical (single) rca cable like mine, that was a long and tedious task. You can't just pull it through, it constricts down and won't happen (like a Chinese finger trap). Rather, you have to push the loom together to make it fat, and inch the cable through the fat part, slide down the loom thee inch of two you bunched up, and repeat. I needed a 30 ft run, it probably took me 30-40min to do this. I would NOT recommend for long runs or wiring that is any larger than the rca jack. Otherwise, the finished product looks good and feels durable enough, just a real PITA to do.

These make a big cosmetic difference in the engine bay.

This doesn't fit over a standard RJ45 plug without ripping and fraying. Works good if you sleeve the cable before crimping though.

I've always loved this product and usually keep quite a bit on hand. If you like clean wiring - this is your product! Very well priced and takes your project quality to the next level.

Use this stuff lots. Great for protecting wire exposed to any possible abrasion. Trailers, tractors, etc. Expands to accommodate install, connector size change etc. recommend, I use a lot so a roll is nice

Basically a giant Chinese finger trap. I understand it is supposed to heat shrink, but you risk damaging your cords if you heat it enough to prevent fraying, and no matter where you heat it, it is inconvenient. Maybe I am wrong, but there are no instructions to tell me otherwise. Would be 1000x better if it came with some kind of sealer or clasp for the trimmed ends, or with just basic instructions.