AKKON - For 01-05 Lexus Altzza IS300 Black Bezel Halo Projector DRL Daylight LED Strip Headlights Replacement Pair

Le quedaron prefectos, le cambió la apariencia, ahora luce mejor.

Very nice head lights and work perfect

Installed a new set of these on my car about a month and a half now (February 2020). Very stylish. Had to connect both the halo & “drl” lights together then connected them to the car’s park light cable. Be prepared to transfer/purchase your ballast boxes if need. These aren’t supplied with this product. Transfer yourself ballast cover. The ones supplied with these headlights are too shallow to properly seal the ballast. Easy to swap/add the ballasts. Be prepared to remove your bumper for easy installation. Doesn’t require too much intelligence to install the lights. My car has aftermarket overfenders so I have to use a bracket to properly hold the rear of the light in place. Oem fenders shouldn’t have that problem. Driving at night you can see the black “dead” spot in the illumination. I’m thinking because of the design of the black housing casing. Just yesterday noticed that both pair have a leaky seal. Water droplets have formed throughout the entire lens. I messaged the company via Amazon for an answer. Hopefully something as simple as a sealant can be applied to stop this from happening. I had the exact same type of chrome head lights prior and didn’t have that problem. I’ve gotten nice compliments on the lights just beware if there’s a factory defect with them. I would refer these but with caution.

After Install the lens doesn't block the light bulb filament. So when you drive at night you see this really really really annoying bulb shadow hole on the road on both sides. Also unable to adjust the angles because its to tight inside the cars body. Don't buy it guys. Also the Led Strip wired to my parking light still doesn't work. China POS

Alot of water get in them. Burns out the light bulbs.

These lights look really good but they're a pain to wire. The halos are supposed to be plug n play but they didnt work so i had to hard wire them with the led strip and splice them both into the low beam wires. Also the design of the headlights is very sloppy. I have a black collumn in my line of sight that im guessing the barrier between the lo and highs make. Also even though the main force of my high beans is angled correctly there light that shoots all over the place. It will literally shoot beams of light into the trees directly above you. If i had know about this earlier i wouldve went with Spec D lights.

Good stuff but the running lights on the bottom don't wrk 4 me. Might be my fault being that I installed it myself. Look good tho.

This has given my vehicle a fresh look up front. The brightnenss and beam are adequate and clear.