RC4WDZ-S1089 Wired Winch Control Unit

I bought this to control a (RC4WD 1/10 Warn 9.5cti Winch). No instructions are included, but if needed are available online. Comes with the necessary cables. I plugged one cable into the winch the other into the receiver. You will need a controller with a 3 position channel. I use a DUMBORC X6 controller with has the necessary channel. Powered everything up and it worked great.

Works how it should does what it's supposed to

I have the flysky gt5 and used on channel 4 I burned up my motor and fried winch controller. Did not know I hit switch and was left on. It smoked it within a minute. Warranty took a little time but also ordered the one with the key fob to replace so I don't make the same mistake. In all worked like it should.

Works as it should. Does not work with the Tactic TTX300 as a review said it did.

Easy to install and does the job. Controls my winch with no problem at all.

Stopped working after two runs. Tried other “AUX” slots, rebinding with no luck. Purchased another one with the same problem.

By the time I got the winch and this control unit it was pretty pricey and unless your pulling less then 6lbs I’d advise you to get the warn winch with the 50lbs dead lift anything else will not pull your truck out the mud or up the cliff sideI’ve heard great things about servo winches idk just my thoughtsDoes what it’s suppose to do and I put in a balloon to make it water resistant but it’s not a solid seal so continues submersion will ruin it

Very easy to hook up